Phantom-tech Viewpoint VI0508 Manuel d'utilisateur télécharger pdf (Page 4)

Getting to Know the Viewpoint Screen

Before beginning, become familiar with the

Viewpoint Screen and the door on which it

will be installed.

The Viewpoint Screen accommodates both

in-swing and out-swing doors. In-swing

doors open to the inside of the home and

require the Viewpoint Screen to be

installed on the outside of the home.

Out-swing doors open to the outside of the

home and require the Viewpoint Screen

to be installed on the inside of the home.

Does the Viewpoint Screen t the

Door Opening?

Make sure that the Viewpoint Screen

will t the door. This application

will accommodate an opening of

up to 36” (914 mm) wide, and between

76 9/16” (1,947 mm) and 80 9/16”

(2,047 mm) high. If the door opening is

larger than that, the Viewpoint Screen can

still be installed by attaching a ller strip

under the door frame to reduce the height of

the door opening. Refer to page 6 for details.

NOTE: The Viewpoint Screen can only be

shortened by 4” (100 mm) to a minimum

height of 76 9/16” (1,947 mm). If the door

opening is smaller than this, the Viewpoint

Screen will not accomodate the door.

4

Is the Door Opening Square?

For the Viewpoint Screen to operate

effectively, the door opening must be

perfectly square. Using a Carpenter

Square, check to ensure that the door

frame is square. If not, use shims to

bring the door frame to square before

beginning installation.

Is there enough Mounting Surface?

The Viewpoint Screen is a recess

mount screen that installs on the

inside surface of the door frame.

A minimum Mounting Surface of

1 3/4” (45 mm) is required. This

Mounting Surface must be at and

ush, and at a right angle (90˚)

to the door.

Door Frame

Corner Cover

Mesh

Mounting Bracket

Clip

Fixing Strip

Tension Wire

Bottom Rail

Sliding Bar Bottom Cap

Catch Frame

Latch Hole

Latch

Sliding Bar

Top Rail

Rollers

Mounting Surface

Viewpoint Screen

1 2 3 4 5 6 7 8 9 ... 15 16

Commentaires sur ces manuels

Pas de commentaire